STANDARD FEATURES

• each tube is tested at 185 Bar before installation
• shell diameters for standard units range from 4” to 20” (100 – 500 mm)
• shells are available in carbon steel, stainless steel, glass lined steel, PTFE lined steel, borosilicate glass
• nominal tube length is from 1000 to 6000 mm
• surfaces from 0,5 to 95 m2
• tubing diameter Ø 12,7 mm Ø 14 mm, Ø 19 mm
• single pass or multi pass design
• double Tubesheet design (GMP)
• horizontal or vertical installation
• temperature range from –30°C to +320°C
• pressure range from –1 Bar to +12 Bar
• Special features on request.
• CE, ATEX, ASME code, FDA full compliance.
• Double Tubesheet Design It is possible to separate the process fluid and the service fluid with a separation chamber, so that in case of o-ring leaking no mix will occur between the two fluids. This chamber can be pressurized at a higher pressure than the than the process one to avoid leaking in case of o-ring failure.

STANDARD FEATURES

• Tubesheet material: pure, vergin, PTFE 25% SiC filled
• each tube is tested at 185 Bar before installation
• shell diameters for standard units range from 4” to 20” (100 – 500 mm)
• shells are available in carbon steel, stainless steel, glass lined steel, PTFE lined steel, borosilicate glass
• nominal tube length is from 1000 to 6000 mm
• surfaces from 0,5 to 95 m2
• tubing diameter Ø 12,7 mm Ø 14 mm, Ø 19 mm
• single pass or multi pass design
• double Tubesheet design (GMP)
• horizontal or vertical installation
• temperature range from –30°C to +320°C
• pressure range from –1 Bar to +12 Bar
• Special features on request.
• CE, ATEX, ASME code, FDA full compliance.